Shaohua Zhang
材料科学技术（英）
The orientation dependence of creep rupture lives of a single crystal superalloy at 760 oC/760 MPa was investigated. The orientations of the specimens tested were about 30o away from [001]. The results showed that specimens with orientations on the [001]-[011] boundary had the longest rupture life. The deformation of these specimen were controlled by a/2<110> slip and a few stacking faults with two orientations were observed. On the other hand, specimens with orientations near the [001]-[011] boundary or on the [001]- [¹111] boundary showed short rupture lives, and stacking faults with single orientation were observed in these specimens. The rupture properties and the deformation mechanisms were discussed based on the dislocation
pattern and the calculated Schmid factors for different specimens..
关键词:
Single crystal superalloy
Jian Zhang Jinguo Li Tao Jin Xiaofeng Sun Zhuangqi Hu
材料科学技术（英）
A single crystal Ni-base superalloy was processed with withdrawal rates between 2 and 7 mm/min. The as-cast microstructures, heat treatment response and creep property have been characterized as a function of the withdrawal rate. As expected, the primary and secondary dendrite arm spacing decreased with increasing withdrawal rate; microsegregation degree and porosity distribution were also varied with different withdrawalrates. The withdrawal rate of 2 mm/min resulted in a noticeable residual microsegregation even after full heat treatment. The samples solidified at 7 mm/min exhibited a high density of cast porosities, and this led to a dramatical decline of the creep strain. 4 or 6 mm/min appeared to be the optimum withdrawal rate in the present study, which resulted in a uniform microstructure and an optimum density of cast porosity.
关键词:
Single crystal superalloy
,
Withdrawal rate
,
Microstructure
,
Creep
Wen LI
,
Tao JIN
,
Xiaofeng SUN
,
Yi GUO
,
Hengrong GUAN
,
Zhuangqi HU
材料科学技术（英）
The Ni-base single crystal superalloy was bonded by the transient liquid phase (TLP) bonding, using a Ni-base flexible metal cloth as an insert alloy. TLP bonding of superalloy was carried out at 1473~1523 K for 0.5~24 h in vacuum. The [001] orientation of each test specimen was aligned perpendicular to the joint interface. The bonded region was observed by optical microscopy, and the microstructural and compositional analyses across the bonded interlayer were performed by using a scanning electron microscopy (SEM). The electron back scattering diffraction (EBSD) method was applied to determine the crystallographic orientation. The results indicated that the chemical homogeneity across the bonded region can be achieved, and γ′ phase both in the bonded interlayer and in the superalloy substrate is almost identical, while the bonded interlayer had almost matched the crystallographic orientation of the bonded substrates.
关键词:
Single crystal superalloy
,
null
,
null
,
null
